Two automations, two different problems

A schedule runs times. Flam Pilot and Eco+ decide, based on the room's actual temperature and how cold it is outside.

Flam PilotArriving on time Eco+Holding without forcing

Arriving on time

Flam Pilot

You set your slots. It lights early enough for each one.

A slot is a time and a temperature: 20 °C from 7 to 8:30 am on weekdays, 21 °C in the evening, 20 °C at the weekend. For each one, Flam Pilot works out when to light, based on the outdoor temperature and your home's inertia, so that the room is within your comfort range from the start. The ignition time therefore moves from one day to the next — that is precisely the point. Early ignition works with Eco+, included in Flam+.

A week of Flam Pilot

MoMonday
20 °C21 °C
TuTuesday
20 °C21 °C
WeWednesday
20 °C21 °C
ThThursday
20 °C21 °C
FrFriday
20 °C21 °C
SaSaturday
20 °C
SuSunday
20 °C

0:006:0012:0018:0024:00

Your slots: a time, a temperatureThe preheat, calculated by Flam Pilot

Wednesday, frosty night: ignition starts at 5:15 instead of 5:50. Sample week — actual times depend on your home and how cold it is outside.

Same goal, two nights

Mild night

6 °C outside

Ignition decided by Flam Pilot

6:10

20 °C

3:005:007:00

Within your comfort range at 7:00 ✓

Frosty night

−5 °C outside

Ignition decided by Flam Pilot

5:05

20 °C

3:005:007:00

Within your comfort range at 7:00 ✓

65 min apart for the same goal. A fixed-time schedule would have heated an empty house on the mild night, or arrived late on the frosty one.

Illustration — actual times depend on your home and how cold it is outside.

Day by day

Weekdays, weekends or each day on its own, as many slots as you want.

One preheat per slot

Its time follows the cold outside and your home's inertia, not a habit.

Outside your slots, you decide

Stove off or a reduced temperature, for all the times outside your slots.

Included in Flam+ — €2.99 a month, cancel any time.

Holding without forcing

Eco+

Your stove turns smart: it modulates its own flame.

A stove's eco mode knows only two moves: heat at its set power, or cut out. Eco+ varies the power across the stove's five levels — strong when the room is cold, gentle as it nears your target — to keep it around your temperature. And if it has to cut out, it does so when the room was about to leave the margin you chose, not once it already has.

A morning with Eco+

Your target: 20 °CTolerated margin: ± 1 °C The room

Room temperature

20 °C1234

Flame power

6:009:0012:00

1
6:15 — Cold room: after ignition, Eco+ turns the flame up.
2
7:24 — The room nears 20 °C: the flame drops, level by level.
3
9:30 — The temperature was about to go past the top of the margin: Eco+ cuts out first.
4
10:45 — The room falls back towards the bottom of the margin: relight, then the flame rises again.

Illustration of the principle over one morning, Balanced setting — not a measurement.

You choose how much the room can vary

Eco+'s three settings change only one thing: the tolerated margin around your target. Tight, and the room stays as close as possible, at the cost of more frequent relights. Wide, and it varies more, and the stove restarts less often.

Comfort
± 0.75 °C
About 4 ignitions a day*
Balanceddefault
± 1 °C
About 3 ignitions a day*
Economical
± 1.5 °C
About 2 ignitions a day*

0:0024:00

* Figures calculated in simulation across six types of home. The margin is a setting, not a guarantee: the room sometimes leaves it, especially just after a relight.

Five flame levels

The power drops as the room gets closer to the target.

Fewer restarts

Fewer shutdowns and relights than with the stove's eco mode — each one wears the igniter and dirties combustion.

A margin of your choice

± 0.75, ± 1 or ± 1.5 °C around your target: Comfort, Balanced or Economical.

Included in Flam+ — €2.99 a month, cancel any time.

Automations that leave you in control

Flam Pilot and Eco+ light your stove without asking you. Three safeguards frame that right.

A ceiling of 10 ignitions a day

Beyond that, Flam no longer lights the stove on its own, and alerts you.

You stay in control

You can take back control at any time from the app.

It's all in the history

Every ignition, every target, with its outcome: planned, confirmed or failed.

The schedule itself stays free

Charging for scheduling would mean charging for what the manufacturer's app already gives you. What Flam+ sells is the automatic decision and the continuous monitoring — not the right to choose your own hours.

Your stove deserves better than a remote control

Control and scheduling free for life. Flam+ can be tried for 10 days, no payment card required.

Coming soon to Google Play
Coming soon to the App Store